Bell SCA-2MR Especificações descarregar pdf (Página 23)

Start: set start frequency of the digital sine wave generator. In order to avoid

overlapping frequencies, the start frequency may not be set to any value

above the stop frequency. Range: 50Hz - 10kHz.

Stop: set stop frequency of the digital sine wave generator. In order to avoid

overlapping frequencies, the stop frequency may not be set to any value

below the start frequency. Range: 50Hz - 10kHz.

Test: Starts frequency sweep within the set paramenters

User command: YES / NO .

Page 3

This function is identical to that of page 2, however it serves to check CH.B

Page 4

Parameters:

Sine Test: Activates the automatic impedance check.

(as in funcions and features guideline p.3)

User command: ON / OFF

Power CTRL: Activates the „Auto Power Off“ function

Re.: Protect LED at front

(as in funcions and features guideline p.3)

User command: ON / OFF

Remote Control*: Enables / disables remote control via the „Remote Active“ switch.

Re.: operational features (front): “Remote Active“ Switch.

User command: ENABLE / DISABLE .

*(function disabled in software release 1.0)

1 2 ... 18 19 20 21 22 23 24

Sem comentários

Bell SCA-2MR Especificações Página 23