Bell EXPRESSVU Informações Técnicas descarregar pdf (Página 3)

Using The System

Using The Remote Control

Page 3-3

ABOUT THE IR REMOTE

The IR remote uses infrared light to control the receiver and has a maximum range

of 40 feet. You must point the remote directly at the receiver, with no solid objects in

the way.

Do NOT change the address of an IR Remote. The IR Remote Control is programmed

to control the satellite receiver when packaged. Unless you have two receivers in the

same room, you should not need to change the address. If you have two receivers in the

same room and the remote is controlling both, perform the Changing the Remote

Address procedure on page 3-9 to change the address of the remote to specifically

control one satellite receiver.

4100_Ch3_eng 6/15/05 8:34 AM Page 3

1 2 3 4 5 6 7 8 ... 55 56

Sem comentários

Bell EXPRESSVU Informações Técnicas Página 3