Bell EXPRESSVU Informações Técnicas descarregar pdf (Página 5)

Using The System

Using The Remote Control

In SAT mode, press the MENU button to open the Main menu.

POWER

In SAT mode, press the POWER button to turn the receiver ON or

OFF. The green power light on the receiver front panel lights up to

indicate the receiver is ON. For each mode, the POWER button will

turn that device on and off. Note: You must program the remote for

that device.

PAGE UP OR DOWN ARROWS

In SAT mode, press the PAGE UP button or the PAGE DOWN

button to scan, page by page, through the Program Guide, a

Theme Categories list, a Favourite List, an Event Timers list,

or a list of channels.

MUTE

In any mode, press the MUTE button to temporarily turn off the

sound. Press it again to restore the sound. The MUTE button works

only if you have programmed the remote. See “Programming the

Remote to Control Other Devices” on page 3-5. If, after programming

the remote, you still cannot turn up the volume, your receiver may

have its own volume. Try one of the following:

• Push and hold the POWER button for 5 seconds. Or,

• Using the Programming the Remote to Control Other Devices

(Page 3-48) procedure in SAT, TV, or VCR mode, the code 222

will program the remote to control the sound volume in some

satellite receivers. Note: To control your TV, you will need to

reprogram the remote back to the code that works for your

particular TV.

VOLUME

In any mode, press the plus (+) side of the VOLUME button to

increase the sound volume. Press the minus (-) side of the VOLUME

button to reduce the sound volume. This button works only if you

have programmed the remote. See “Programming the Remote to

Control Other Devices” on page 3-48. If, after programming the

remote, you still cannot turn up the volume, your receiver may have

its own volume. Try one of the procedures described under Mute.

Page 3-5

4100_Ch3_eng 6/15/05 8:34 AM Page 5

1 2 3 4 5 6 7 8 9 10 ... 55 56

Sem comentários

Bell EXPRESSVU Informações Técnicas Página 5